Metres to Feet and Inches

How the metres to feet and inches works

Converts metres to feet and inches and back. The calculator takes your dimensions and supplier rates, applies a standard UK trade formula, and returns a quantity with an indicative cost. Every figure is an estimate — site conditions always move the final number.

Typical UK conversions and units wastage

Conversion is exact — wastage only enters when you then order against the converted figure. Apply category-specific wastage to the output rather than the conversion itself. Our defaults reflect common UK trade allowances, and can be adjusted upwards for non-standard geometry or downwards where experience supports a lower figure.

What this tool does not do

It does not replace a professional quote, factor regional pricing, assess structural adequacy, or confirm Building Regulations compliance. Those remain the responsibility of a suitably qualified designer, surveyor, or your building control officer.

On-site considerations for metres to feet and inches

UK trades mix metric and imperial routinely (joists sold in metric lengths but boards priced in ft²). Double-check which unit the supplier is quoting.

Building Regulations and compliance

Building Regulations are published in metric. SI units are the only ones accepted on Building Control submissions. When in doubt, a pre-application enquiry to the local authority can give early clarity, which tends to be less costly than retrospective correction.

Before you order

Noting the original unit alongside the converted figure in your quote — it avoids disputes if the supplier works in the other system. Cross-checking the calculator’s output against a supplier quote helps catch differences in pricing assumptions — ask for exact product specifications (grade, finish, batch number) and confirm delivery timescales against your programme.

Adjusting the defaults

Every input in this calculator is editable. Enter your own dimensions, supplier prices, and wastage allowance — the output recalculates instantly. If the defaults feel off for your region or project type, your own numbers always override them.

Using this metres to feet and inches alongside other BuildMetricLab tools

This calculator works best as part of a planning workflow. Pair the quantity with our project contingency, labour-hours, and material-cost calculators to build a complete estimate before you pick up the phone to a supplier. All BuildMetricLab tools run entirely in your browser — no sign-up, no data sent anywhere, and every formula is shown on-page so you can audit the maths.